Not sure if I am being really dumb here...
I have a new RB750GL, powered it up & connected via winbox on default 192.168.88.1 (actually via MAC).

I wanted to allow management via Ether1 (gateway port) so went into ip firewall & changed drop rule on ether 1 to accept.
I then got 'router disconnected', when I logged back in the rule was unchanged.

Basically I CANNOT make any changes to the firewall rules - I get router disconnected.

All the log shows is user logged out (not a reboot or anything).

I can change the IP address on the LAN side...

Is there something I need to do to 'unlock' this configuration?

Thanks

David

Duh - said it was a dumb question...

For some reason the MAC connection dropped randomly, was uploading new 5.9 & it dropped so once I set an usable IP (actually DHCP Client on LAn ports) then I could connect & amend firewall settings & then connect on Wan port..


David