I have a hotspot 433 composed of three eth intfs
One is connected to a switch full of access points
While the other two are bridged together and
connected to the adsl router and to a syslog storage system
It has been running fine for over six months now
I need to change the ISP and chose to change the addresses of
both eth1 and eth3 to a new subnet
Following both my first attempts the hotspot stopped working
The dhcp dishes out the addresses but the login screen doesn't
display and users can't reach the Internet.
I have even tried to keep the original address schemes and adapt
the adsl router instead, to no avail. I even bought a new modem
assuming that the ISP's modem was at fault : same result !
I'm not sure what else to try/suspect
Any ideas ?