I've Setup My Router with below configs but , Clients cant connect with PPPoE on 2ndRouter
Don't know where is wrong !!?
My Network :
Code: Select all
MAINROUTER -----[PPPoE] & [EoIP] -----> 2nd Router ----[eth3]---> {... Clients...)-----------------------------------------------------MyConfigs-----------------------------------------------------------
[MAIN ROUTER]
IP ADDRESS:
Code: Select all
[admin@MikroTik] /ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK INTERFACE
0 10.0.0.1/30 10.0.0.0 ether1
Code: Select all
[admin@MikroTik] > /inter eoip print
Flags: X - disabled, R - running
0 R name="eoip-remote" mtu=1500 l2mtu=65535 mac-address=FE:64:05:84:30:F4 arp=enabled local-address=0.0.0.0 remote-address=10.0.0.2 tunnel-id=0
Code: Select all
[admin@MikroTik] /interface> pppoe-ser ser print
Flags: X - disabled
0 service-name="service1" interface=eoip-remote max-mtu=1480 max-mru=1480 mrru=disabled authentication=pap,chap,mschap1,mschap2 keepalive-timeout=10
one-session-per-host=no max-sessions=0 default-profile=default
Code: Select all
[admin@MikroTik] > ping 10.0.0.2
HOST SIZE TTL TIME STATUS
10.0.0.2 56 64 0ms
10.0.0.2 56 64 0ms
10.0.0.2 56 64 0ms
10.0.0.2 56 64 0ms
sent=4 received=4 packet-loss=0% min-rtt=0ms avg-rtt=0ms max-rtt=0ms
[2nd Router]
IP Address:
Code: Select all
[admin@MikroTik] /ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 10.0.0.2/30 10.0.0.0 10.0.0.3 ether2 Code: Select all
[admin@MikroTik] /interface eoip> print
Flags: X - disabled, R - running
0 R name="eoip" mtu=1500 l2mtu=65535 mac-address=FE:FD:C5:6E:62:3C arp=enabled remote-address=10.0.0.1 tunnel-id=0
Code: Select all
[admin@MikroTik] /interface bridge> print
Flags: X - disabled, R - running
0 R name="bridge1" mtu=1500 l2mtu=65535 arp=enabled mac-address=FE:FD:C5:6E:62:3C
protocol-mode=none priority=0x8000 auto-mac=yes admin-mac=00:00:00:00:00:00
max-message-age=20s forward-delay=15s transmit-hold-count=6 ageing-time=5m
[admin@MikroTik] /interface bridge> port print
Flags: X - disabled, I - inactive, D - dynamic
# INTERFACE BRIDGE PRIORITY PATH-COST HORIZON
0 I ether3 bridge1 0x80 10 none
1 eoip bridge1 0x80 10 none 
