After cloning one rb1000 into another on the new one suddenly the time wasn't updated anymore.....??
I don't know why but time request from either routers on my lan querying on the internet wasn't working nor the main gateway itself could get its time updated.
I disable all possible firewall filter rules (so all at once) but still nothing, although the filter and the torch tool is counting the traffic (udp port 123)
After long fiddling I found that the resolve basic window (from my PC) timeserver suddenly did work! With all my firewall rules enabled. So, suddenly all my 4 different timeserver I used for year don't work no more? Strange.
But, any router behind my main gateway that is querying my main gateway (with ntp package enable) can't get their clocks updated from my main gateway. I tried all possible setting on both the main gateways' ntp server settings as the sntp settings of the client.
Yet again all incoming firewall rules disabled in the main gateway but still nothing.
Message produced is "server-not-synchronisez" where the main router itself shows "synchronized". So I don't know anymore.
Each time when I copy or upgrade my main gateway (and don't change anything in the config!) I seem to have problems getting the time server package to work!
Since not any setting works, can somebody tell me what is the preferred setting of the server in the main gateway, and the client setting on each client querying this main router?