Hi
after upgrade to V6.1 the lcd of touch screen is not working properly
i am not able to slide between interface graphs

can any one figure out the issue??

I have the same problem.. Moves a bit, then the screen locks up. Everything else seems ok, but have to power-down or reboot to start the process all over again. Weird...

-tp

did you try "recalibrate"?

yes i tried it twice
after each calibrate it works for some time then back to old state

can you make a "lcd screenshot" when the screen hangs and doesn't move?
can you also make a supout.rif file at the moment when you do this?

do i have to take an image of lcd with camera??

i did a full reset of the device and re configured and now it's working perfectly
but normis please have a look at ticket 2013061766000953 regarding packet marking

the LCD menu has a screenshot option

ros code

[admin@mikrotik] > lcd take-screenshot

as i told above after reset it's working fine
but i think the upload tx rate of WAN interface is showing wrong rate both on graph and in interface status
please refer to ticket 2013061866000997

Thanks

admins please close the ticket above
i have found the problem
there was an ddos attack to my router