Hello, I have a problem that I think is causing me some grief.
I have a ubiquiti toughswitch pro powering 4 ubiquiti radios that trunk back to an RB1100AHx2.
In the past week or so I have noticed TX drops on the vlan interfaces. Reading around the forums I mostly see posts about TX drops with i386 boxes.
I have posted about this in the ubiquiti forum as well as I'm a tad bit suspect of the toughswitch pro.
http://community.ubnt.com/t5/ToughSwitc ... 95#U511095
Is there anything on the RB1100 that I need to be looking at that might help this problem?
I run MPLS/VPLS over a routed network using OSPF. I increase the MTU on all radios to allow the traffic to pass. I also enabled jumbo frames on the toughswitch.