Community discussions

MikroTik App
 
adairw
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 60
Joined: Sun Jan 29, 2012 6:32 pm

TX Drops on VLAN Interfaces

Wed Jul 10, 2013 6:35 pm

Hello, I have a problem that I think is causing me some grief.

I have a ubiquiti toughswitch pro powering 4 ubiquiti radios that trunk back to an RB1100AHx2.
In the past week or so I have noticed TX drops on the vlan interfaces. Reading around the forums I mostly see posts about TX drops with i386 boxes.

I have posted about this in the ubiquiti forum as well as I'm a tad bit suspect of the toughswitch pro.
http://community.ubnt.com/t5/ToughSwitc ... 95#U511095

Is there anything on the RB1100 that I need to be looking at that might help this problem?

I run MPLS/VPLS over a routed network using OSPF. I increase the MTU on all radios to allow the traffic to pass. I also enabled jumbo frames on the toughswitch.

Comments welcome
 
User avatar
NetworkPro
Forum Guru
Forum Guru
Posts: 1370
Joined: Mon Jan 05, 2009 6:23 pm
Location: Worldwide
Contact:

Re: TX Drops on VLAN Interfaces

Wed Dec 11, 2013 11:30 am

Did you find the reason or what did you do to fix this ?

Regards.
wiki.mikrotik.com/wiki/NetworkPro_on_Quality_of_Service
 
adairw
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 60
Joined: Sun Jan 29, 2012 6:32 pm

Re: TX Drops on VLAN Interfaces

Wed Dec 11, 2013 5:47 pm

I tried MANY things and have gotten it to slow down considerably but it is still happening a little.
I couldn't even begin to tell you what did the most good. it's been to long and many things tried...

Who is online

Users browsing this forum: GW156, sindy and 54 guests