Page 1 of 1

TX Drops on VLAN Interfaces

Posted: Wed Jul 10, 2013 6:35 pm
by adairw
Hello, I have a problem that I think is causing me some grief.

I have a ubiquiti toughswitch pro powering 4 ubiquiti radios that trunk back to an RB1100AHx2.
In the past week or so I have noticed TX drops on the vlan interfaces. Reading around the forums I mostly see posts about TX drops with i386 boxes.

I have posted about this in the ubiquiti forum as well as I'm a tad bit suspect of the toughswitch pro.
http://community.ubnt.com/t5/ToughSwitc ... 95#U511095

Is there anything on the RB1100 that I need to be looking at that might help this problem?

I run MPLS/VPLS over a routed network using OSPF. I increase the MTU on all radios to allow the traffic to pass. I also enabled jumbo frames on the toughswitch.

Comments welcome

Re: TX Drops on VLAN Interfaces

Posted: Wed Dec 11, 2013 11:30 am
by NetworkPro
Did you find the reason or what did you do to fix this ?

Regards.

Re: TX Drops on VLAN Interfaces

Posted: Wed Dec 11, 2013 5:47 pm
by adairw
I tried MANY things and have gotten it to slow down considerably but it is still happening a little.
I couldn't even begin to tell you what did the most good. it's been to long and many things tried...