Community discussions

MikroTik App
 
infused
Member
Member
Topic Author
Posts: 313
Joined: Fri Dec 28, 2012 2:33 pm

SIP QoS

Sun Sep 01, 2013 12:44 pm

Yes, this question has been asked a lot. However, mine is slightly different.

I know my sip providers ip ranges for RTP and Voip. So I was thinking:

1) Add all addresses to Address List
2) Mangle on Address List to Mark Connection
3) Queue with priority 1 based on marked connection

How well would this work in practice?
 
Lakis
Forum Veteran
Forum Veteran
Posts: 703
Joined: Wed Sep 23, 2009 7:52 pm

Re: SIP QoS

Sun Sep 01, 2013 2:00 pm

Just add port (SIP port) priority

If ur Internet connection is very very good and u always have spear of Internet u dont have to add noting
 
infused
Member
Member
Topic Author
Posts: 313
Joined: Fri Dec 28, 2012 2:33 pm

Re: SIP QoS

Sun Sep 01, 2013 2:56 pm

Slow, congested connection for this customer. So I need it.
 
User avatar
pcunite
Forum Guru
Forum Guru
Posts: 1345
Joined: Sat May 25, 2013 5:13 am
Location: USA

Re: SIP QoS

Sun Sep 01, 2013 5:03 pm

Read my guide (work in progress).
 
infused
Member
Member
Topic Author
Posts: 313
Joined: Fri Dec 28, 2012 2:33 pm

Re: SIP QoS

Mon Sep 02, 2013 12:44 am

Your guide looks good, but it's a bit much for what I'm wanting to achieve. When would you mark connections over packet?

Also, If I create a default queue of 10m/10m at priority 8, then a sub queue with 2m/2m with priority 1 which has the marked sip traffic, would that work?
 
User avatar
pcunite
Forum Guru
Forum Guru
Posts: 1345
Joined: Sat May 25, 2013 5:13 am
Location: USA

Re: SIP QoS

Mon Sep 02, 2013 2:33 am

Your guide looks good, but it's a bit much for what I'm wanting to achieve. When would you mark connections over packet?

Also, If I create a default queue of 10m/10m at priority 8, then a sub queue with 2m/2m with priority 1 which has the marked sip traffic, would that work?
You should mark connections if those connections are somewhat long running, say over a minute, and there are several of them in parallel. Imagine you have several phone calls going on, you can guess the CPU usage from stamping every single packet for 5 active calls.

When it comes to queue creation, I'm still learning. But basically put marked VoIP connections in a queue that will never actually be limited. Don't put HTTP traffic in that same queue for example. Then make another queue for packets you know will most likely exceed your bandwidth. I don't yet understand the concept of priority. Priority does not prevent packets from dropping, which you must never do with VoIP.
 
infused
Member
Member
Topic Author
Posts: 313
Joined: Fri Dec 28, 2012 2:33 pm

Re: SIP QoS

Mon Sep 02, 2013 2:50 am

Yep. Sounds like what I'm doing.

I'm just trying to sus out these queues.

Who is online

Users browsing this forum: benlg, xristostsilis and 82 guests