Page 1 of 1

Will not reboot

Posted: Wed Apr 05, 2006 8:37 am
by kaver68
When I issue a system reboot command, the system will respond with what looks like the correct message, but it never reboots...it just sits there. I was using the Crucial 128 Meg compact flash and switched over to a San Disk 64 Meg flash thinking it was the corruption problem that I heard about last week, but it still does not reboot.

It hangs at "Restarting system." and never comes back up until I cycle the power on the rascal.

I've even upgraded to version 2.9.18 and still the problem is there.

I'm using the standard Wrap board with 2 Ethernet interfaces.

Any ideas?

Kelly

Posted: Wed Apr 05, 2006 9:05 am
by sergejs
kaver68,
Do you have 'routerboard' package installed ?

Posted: Wed Apr 05, 2006 9:14 am
by kaver68
Hi,

Nope.

Kelly

Posted: Wed Apr 05, 2006 9:15 am
by sergejs
Install 'routerboard' package, than reboot command has to work properly.

Thanks!

Posted: Wed Apr 05, 2006 10:11 am
by kaver68
That did the trick!

Thanks for being around so late at night!


Kelly

Posted: Wed Apr 05, 2006 10:15 am
by normis
it's 10AM his time :) no night here

Posted: Thu Apr 06, 2006 12:17 pm
by djape
it's 10AM his time :) no night here
:D