I have included an example of what I have setup.
The customer is using a RB750GL with the following bridge setup
I am managing the device on ether5 in vlan1 using a private IP.
Code: Select all
# INTERFACE BRIDGE PRIORITY PATH-COST HORIZON 0 ether3_customer Internet_Bridge 0x80 10 none 1 I ether4_customer Internet_Bridge 0x80 10 none 2 ether5_vlan2021 Internet_Bridge 0x80 10 none 3 ether2_customer Internet_Bridge 0x80 10 none 4 ether1_manage Internet_Bridge 0x80 10 none
Ether5 connects to a fiber transceiver and the fiber runs back to our office. There it connects to a Cisco 3750 with switchport trunk allowed vlan 2021,1.
On the Cisco vlan2021 is assigned their public gateway IP.
On another port the Cisco with switchport trunk allowed vlan 2021,500,1,2004 connects to our watertower via fiber to an HP procurve switch with its uplink port configured to allow vlans 2021,500,1,2004.
Port 4 of the HP switch is set to allow vlans 2021,1 and connects to a Ubiquiti AP in AP WDS bridge mode. This AP connects to a CPE in Station WDS Bridge mode.
The CPE is currently not connected to the customer's RB750GL. They have to plug it in manually to Ether5 when the fiber link goes down.
I would like to have it connected to Ether4.
What would be the best way to set this up so they have automatic failover?