Page 1 of 1

How to properly setup RB951G-2HnD RouterOS L4 pppoe client.

Posted: Wed Nov 27, 2013 9:48 am
by michas100
Hello like in the topic I have a aDSL ISP connection and when I use pppoe client on my microtik and modem is in the brigde mode, my connection is much slower than when it isn't in bridge mode(pppoa vcmux mode on the aDSL modem).
I have a question how properly set up pppoe client on microtik, there are a few parameters eg. max-mru,max-mtu (for now the are defaults) ofcourse username and pass are correct. Ant idea?

.... sorry for my English.
Regards
Michal

Re: How to properly setup RB951G-2HnD RouterOS L4 pppoe clie

Posted: Fri Nov 29, 2013 9:13 pm
by ghi000
I don't know what the defaults are, but you can try with MTU and MRU set to 1492. PPPoE is inferior to PPPoA, so do not expect too much.
You can also remove the dhcp client on eth1 and, why not, ARP disabled.
Maybe somene with more experience and knowledge will help you :)