have a vpls connection running across network..(works fine)
customer wants 10mb usage currently.
Currently I have controlled the Bandwidth by setting the port speeds on both end devices as 10mb Full duplex.
if I set them to 100 full duplex and try to queue the traffic it doesn't queue the traffic at all.
it gives them full capacity
on one end I have this config as a queue but it is not working.
Customer is off port 9.
name="VPLS-Customer" target-addresses="" interface=ether9 parent=none
packet-marks="" direction=both priority=8
queue=default-small/default-small limit-at=30M/30M max-limit=30M/30M
burst-limit=0/0 burst-threshold=0/0 burst-time=0s/0s
total-queue=default-small
I just want to queue up/down traffic on a port/interface nothing elaborate
any Ideas?
Currently running v5.18
I have other queues on this same router that are working.. just this one that doens't
I suspect it may be because of the vpls but don't see why..
Thanx