Are those 2011UiAS-2HnD by any chance ? I have 3 pieces that i cannot get over 3 weeks of uptime, they hang completely, i need to replug them to get them back online.Hello.
I have three x RB2011s. They all have slightly different configurations, are at different locations, and aren't related to one another. One of them ran fine for a while, but then started freezing regularly. When this happened, the router passed no traffic, and did not respond to a ping on any IP. I could not access it via Winbox when attaching directly to it.
I replaced this with new hardware (but the same backed-up-and-restored configuration). But because I had lost some trust in the unit, and also was concerned it could be a config issue, I installed also another router which took on most of the traffic load and left it doing only a couple of specific tasks. Since then, the problem has not recurred. Though it has only been a couple of days. So I began to think this could have been a hardware issue.
Until today, when another one of the RB2011s at another site appears frozen. It too, appears not to respond to pings on any interface, and is also inaccessible via Winbox.
Any obvious or well-known causes? Is it usual for a MikroTik router to just stop responding? The configs are different. They do both have IPsec policies set up, and are both doing outbound NAT, but there are no other commonalities. Both are on software 6.10 with RouterBoard 3.12.
Already running 6.7 and the routers are in a remote location so i cannot connect a console cable to see what is going on.I had issues using an RB2011 with IPSEC/L2TP and OSPF on ROS Ver 6.10. All IP traffic would die, but LCD/console would work as normal.
If I consoled in and then tried to ping out, I'd get an error about the buffer being full. Only rebooting would resolve the issue.
Downgrading to 6.7 has fixed it.
The problem is not fixed for me by downgrading.McTedson and the others if the problem is fixed by downgrading the RouterOS then it is not a hardware problem. It looks like more a software problem.
Please contact the firstname.lastname@example.org with this problem and also include the support output file.
They way I see it I have exactly the same issues only he's on 6.10 and I'm on 6.7.McTedson, looks like you have different problem (symptoms) like the original post. Please post in other topic about your board problem.
Also contact email@example.com about this problem so we could try to help to fix that.
Hi Rick,Are you moving the backup file back and forth between routers and restoring it that way? That will cause problems on all platforms.