So today I upgraded my Router to 6.11, and reset the configuration, upon startup I choose to remove the default the configuration and started configure it.
What I did was to basically add a couple of VLAN's, created some bridges, disable the WLAN.
I then moved it to its intended location and it wouldn't boot up, no beep or anything, and when looked at, all links would turn on for a second and then just go off and repeat.
So I took it back, netinstalled it, and tried the same procedure again and same thing happened upon reboot.
Netinstalled it once again and this time I just removed the default configuration and rebooted and once again it just kept looping without ever coming on.
Once I downgraded the device to 6.0 its working perfectly though so the unit itself should be good.
What gives? Anyone else ran into the same issue with 6.11?