Ping Loss Issues to RB911 board via a RB750UP
Posted: Fri May 23, 2014 5:24 pm
Alright here is my current problem: I have an AP (RB911 5 GHz) and it is powered by a RB750UP switch. We monitor our connection status via pings and log each ping response that is sent/received by the device. My issue is that when the AP is connected through the switch it will drop 4-5 consecutive pings, effectively killing all connections, then returns back to a normal response time. I have bypassed the RB750UP with a standard Ubiquity POE injector I had on hand and that seems to have solved the problem. Set up is as follows:
RB750UP:
ROS 6.12 FW 3.13
Ports 1-5 bridged
Port 1 - Uplink to main HP switch - flow control tx/rx (same on switch, attempted test off and on)
Port 3 - POE to RB911G-5HPnD - flow control tx/rx all other settings default
RB911G-5HPnD:
ROS 6.12 FW 3.14
wlan1 and eth1 bridged
eth1 - POE/Connection to switch - flow control tx/rx
Can anybody shed light on why this would occur? I can provide screenshots if needed
Thanks!
RB750UP:
ROS 6.12 FW 3.13
Ports 1-5 bridged
Port 1 - Uplink to main HP switch - flow control tx/rx (same on switch, attempted test off and on)
Port 3 - POE to RB911G-5HPnD - flow control tx/rx all other settings default
RB911G-5HPnD:
ROS 6.12 FW 3.14
wlan1 and eth1 bridged
eth1 - POE/Connection to switch - flow control tx/rx
Can anybody shed light on why this would occur? I can provide screenshots if needed
Thanks!