Hello everyone!

After 6.11 update I've got problem with ECMP route configuration. Route rule doesn't work correct if two gateways is specified and one is IP (gateway on network) while second is interface (channel connection).

This: leads to this: in WinBox it's appearing like '1.2.3.1@unknown, pptp-out1' and only pptp-out1 connection is seems working.

To make it works I have to specify ethernet port '1.2.3.1%etherX' (though etherX is the only port on 1.2.3.0/28 network) or change channel interface entry on it's remote IP. And this error (or new rule) is since 6.11 till 6.13.

So why so?

Ok, if no one did I'm answering myself. This is seems due to '1.2.3.1' is an internet address (not from a private network). And once pptp-out1 connection is up this next hope is becoming reachable through etherX directly and pptp-out1 recursively. Therefore it is right to implement route rule with '1.2.3.1%etherX'.

But IMHO this behave is still bugsome. In this case should be only one active path to '1.2.3.1' - the one which is on the interface because of minimal distance.