Hi, yesterday i replaced my RB1100AHx2 with a new CCR1009-8G-1S-1S+. Everything went good except UPS configuration with serial cable (modified as it says on the site http://wiki.mikrotik.com/wiki/Manual:System/UPS). With "old" RB1100AHx2 the ups worked perfectly and was immediately recognized with the same cable. I have successfully removed port seriale0 from console and I tried to add the UPS on Serial0 or Serial1 but that is not recognized (still say that UPS if offline; UPS package is installed).

RB1100AHx2 -> 6.19 and UPS package 6.19
CCR1009-8G-1S-1S+ -> 6.19 and UPS package 6.19

Where am I wrong?

Thanks all

Today i'll try if the 6.20 package solves the problem.

But if I connect the APC UPS to the USB port of ccr1009 does it work? I need an usb hub for power injection?

Thanks!

With 6.20 i have the same problem. When i add the UPS under System/UPS tells me that it's Offline.

Someone have the same problem? UPS package is very useful!

Thanks

i have the same problem