Page 1 of 1

Netinstall

Posted: Mon Jan 19, 2015 6:58 pm
by azurtem
Hi

I have been struggling for the past two hours trying to get netinstall to talk to my CCR-1009
Following a power cut the router won't boot ("loading kernel from nand")

...same issue as : http://forum.mikrotik.com/viewtopic.php?f=3&t=87811

I have set up the CCR-1009 with boot to Ethernet
I activated the Boot server in Netinstall and entered an ip address within the same subnet
I keep getting "Please, check ethernet cable..."

I have tried a direct link, intermediate switch...nothing works
I have even attempted to use DHCP protocol - the router however doesn't attempt to reach the DHCP server

I tested the same setup with an RB433 and it works perfectly

Any ideas ?

thanks
yann

Re: Netinstall

Posted: Mon Jan 19, 2015 8:02 pm
by bajodel
Hi

I have been struggling for the past two hours trying to get netinstall to talk to my CCR-1009
Following a power cut the router won't boot ("loading kernel from nand . ...
double check wich is the correct "boot port" on the CCR and use that ..

Re: Netinstall

Posted: Mon Jan 19, 2015 8:19 pm
by azurtem
Thanks Bajodel

Silly me, I assumed it was port eth1
There is even the indication 'boot' above port n°8 !

thanks
yann