Community discussions

MUM Europe 2020
just joined
Topic Author
Posts: 21
Joined: Sat Mar 23, 2013 7:39 pm

Mikrotik as an SSTP Client to a Windows 2008 R2 Server

Fri Jan 23, 2015 11:57 pm

It's a long story that I will spare you from hearing - But I have a network, several actually, that will be connecting to a Windows 2008 R2 server at a data center using SSTP. RRAS is installed on the server and I can connect flawlessly with any Windows client and ping the private IP address of the server. The public IP is basically firewalled off from anything other than 443 - and even then only from the static publics of these few networks.

I have created an SSTP Client Interface under PPP and it too can connect to this server. It also gets a private IP on the same subnet as the private IP of the server. If I use the ping tool on the Mikrotik and specify the SSTP Client interface, I can ping the private IP of the server. However when I ping from any machine behind the Mikrotik I get nothing.

I have created a route to the remote subnet using the SSTP Client interface as the gateway, seems to make no difference. (LAN) -- (Mikrotik) -- (SSTP Interface) ----TUNNEL---- (Remote Server)

I also made sure to add a NAT rule that traffic from bound for is 'Accepted' so it didn't get NAT'd.

What Am I missing to get traffic from the .2 to .253 subnet??


Posts: 49
Joined: Fri Jun 20, 2014 5:56 pm

Re: Mikrotik as an SSTP Client to a Windows 2008 R2 Server

Sat Jan 24, 2015 2:27 am

Try "ping" on your SSTP server. It seems like your SSTP server doesn't have the proper route for your client's subnet.

Who is online

Users browsing this forum: Cartagena, Costa, jo2jo, MSN [Bot], w32pamela and 116 guests