I have a major in LAN router as RB2011UiAS-2HnD-IN and 2pc RB951G 2HnD-in bridge mode (WISP AP) AP as well as used as a switch to another network segment.
The first bridge works without problems, but the second set identically wants to route, or it can ping.
Anything that'll put into port 2 and writes an error message:
(see. image) and communication with MK stops working until not block the port (eth2), another port (eth3) works without problems.
Code: Select all
bridge port received packet with own address as source address probably loop
Can you think of anything?