hi
my ccr stop in loading kernel from nand when i turn it on.i try net install and use 6.30 pakage but router turn on and again reboot .
use ersion 6.10 router dosent reboot but stop in loadin kernel from nand
what should i do for this problem?

Have you tried doing a NetInstall?? I had a smilar issue with a CCR1009-8G-1S-1S+PC - but solved it by reinstalling RouterOS and later partitioning the flash storage into two 64MB slots.

Have you tried doing a NetInstall?? I had a smilar issue with a CCR1009-8G-1S-1S+PC - but solved it by reinstalling RouterOS and later partitioning the flash storage into two 64MB slots.

yes i use netinstall but still has problem but didnt do partotioning becuse stop in loadin kernel

Are you using a Serial cable to connect to the CCR1009 ?
It should give you the option to boot from the network to uset NetInstall.
That is how I recovered mine.

Are you using a Serial cable to connect to the CCR1009 ?
It should give you the option to boot from the network to uset NetInstall.
That is how I recovered mine.

i connect to router via consul but i see kernel loading failed too.
then i format nand and repartition.now i have 2 partition
nand size is 128
but no when i plug router on lcd write ether boot and then stop and no action.what should i do?
thanks

Stop the boot process on the console and tell the router to boot from the network and have the net install server ready.

http://wiki.mikrotik.com/wiki/Manual:Netinstall

Stop the boot process on the console and tell the router to boot from the network and have the net install server ready.

http://wiki.mikrotik.com/wiki/Manual:Netinstall

I enabled network boot but net install dosent know router.I tried it but no result

Have you configured the router to boot from the network? You should connect Eth8.

Have you configured the router to boot from the network? You should connect Eth8.

Yes I configured to boot from network and I connect eth8

Have you configured the router to boot from the network? You should connect Eth8.

Yes I configured to boot from network and I connect eth8

hi
i boot it from eth and i install ros
but now when i install ros v6.10 i have no problem and router boot but when i install v 6.30.2 router goes loading kernel from nand and stop
do you have any solution for this?
thank you

hello
i have problem when i update my router to new v.now current v is 6.10 and router has no problem but when i update it to 6.30 i see loading kernel from nand and router stop
what should i do?

Bump...

Support? I'm having the same kind of problems on two CCR1036-12G-4S routers. They refuse to boot over ethernet using Netinstall.

Bump...

Support? I'm having the same kind of problems on two CCR1036-12G-4S routers. They refuse to boot over ethernet using Netinstall.

I did it but has same problem again

#Support, some HELP. Same problem CloudCoreRouter 1009-7G-1C-1S+

NAD FAIL, can write, Try NetInstall, and fail after one min .... how to solv these, can i boot fron SD card?


HELP!!!!!

#Support, some HELP. Same problem CloudCoreRouter 1009-7G-1C-1S+

NAD FAIL, can write, Try NetInstall, and fail after one min .... how to solv these, can i boot fron SD card?


HELP!!!!!