I was upgrade my 951ui-2hnd from 6.40 to 6.41 and then i deleted all files in router... Now my 951ui become continually reset... I tried Netinstall but it cant see my router...
How can i fix this?
Go to Bridge -> Ports, remove ether1 and ether2 from the list, go to Interfaces -> Add new -> Bonding, set ether1 and ether2 as slaves, then maybe make the new bonding interface a member of that bridge from which you've removed ether1 and ether2. Done.Now i cant do that cos it say ether1 or 2 already on brigde1 .
Can someone tell me how to create bonding easy way on the firmware 6.41.2
Yes thnx was easy way .also in the end have to add ports with the bond created and brigde ..thnxxx againGo to Bridge -> Ports, remove ether1 and ether2 from the list, go to Interfaces -> Add new -> Bonding, set ether1 and ether2 as slaves, then maybe make the new bonding interface a member of that bridge from which you've removed ether1 and ether2. Done.Now i cant do that cos it say ether1 or 2 already on brigde1 .
Can someone tell me how to create bonding easy way on the firmware 6.41.2
Did you have any of bridge ports disabled?
I'll book a maintenance window for next weekend (10th March) and take a supout before and after upgrading.
I initially thought that it may relate to large number of bridge ports but the example above occurred on a router with 3 bridges, each with pairs...
I can also confirm that. CCR lost about half of bridge ports for no apparent reason after upgrading from 6.41 to 6.41.2. I also had to netinstall one hAP-AC with very simple config (simple CAP with all ports bridget + dhcp on bridge) which went into reboot loop after upgrade.We've had several instances of CCR routers losing bridge ports after upgrading from 6.41 to 6.41.2.