Nice to see this tool updated, it's really handy!
However after a quick test, it doesn't seems like it's working correctly:
If local Tx/Remote Tx speeds are not set, it will just not do anything (if using direction=receive):
If direction is set to send, it starts sending data but at very low rate like 1264bps and never goes above that:
With speeds set manually, TCP testing is now working well:
(deleted the UDP testing screenshots, as Tx sizes were incorrect and prevented it from working... DOH!)
All testing done between directly connected PC and RB800, link at 1Gb/s. Router CPU never went above 50%. Using no firewalls or any software that would prevent it from working.
You do not have the required permissions to view the files attached to this post.
Last edited by r00t
on Fri May 08, 2020 4:59 pm, edited 1 time in total.