Is 6.30.5 on the roadmap?

Do you have any issues that we need to fix?

I have a problem to add ipv6 pool in From Pool field when i add ::/64 ipv6 Addresses.
I make a ipv6-pool in DHCPv6 client but this pool cant display at From Pool filed when i add ::/64 ipv6 Addresses.
When i load a backup from previous ROS, all work ok.
When i make reset configure add configure the router from beginning, i have the above problem.
In addition i have always connect/disconnect when i make pppoe client connections with ipv6 enable.
With previous backup file i dont have the same problem.
The configuration is exactly same.
The only different is I make reset configuration.
I have CRS109-8G-1S-2HnD-IN and the old board is RB951G-2HnD.
The problem is the same with this:
http://forum.mikrotik.com/viewtopic.php?t=61976

There seems to be a serious memory leak in this release that's triggered by viewing ip/firewall/connections in webfig. Once you bring up that page, available memory starts dropping and doesn't stop until you stop the www service. Exiting the browser alone doesn't help. It took my RB912 with 64mb memory only 3 minutes to go from 32mb avail to 2mb avail and a watchdog reboot. This is with about 500-700 connections in the table.

Support ticket created with supout.rif

I am unable to repeat this behavior on any of my routers here. I can leave this page open, but Free Memory stays solid and does not change. Please tell me the number of your support ticket, so I can check the status.

The ticket was 2015091366000031 and I got a response that the fix was in 6.32.1 and that does appear to be the case.

There is a bug in OSPF interfaces.
In Winbox when you add a comment to a ospf interface this goes down and stay for some seconds in the waiting state so run the dijkstra algoritm again and then it return in running state.