Posted this in general but maybe this is more appropriate. I just finished deploying a Dynadish5 and upgraded to 6.34.2 and the latest firmware...
my wireless interface has completely disappeared. I had assigned an ip address prior to the upgrade and now it's shown in red showing "unknown".In the wireless interface section nothing is listed at all. But this is passing traffic just fine. I purchased a lvl 4 license prior to deployment and set it up as an ap bridge..now since the wireless interface controls are non-existent , there is no way to change channels or modes or encryption ...or anything..it's operating as a router to separate a subnet via nat , but I've absolutely no ability to control any wireless parameters..WTH??