Community discussions

 
tommy31
just joined
Topic Author
Posts: 2
Joined: Sat Dec 31, 2016 7:49 pm

CRS125 ether3 fault

Sat Dec 31, 2016 8:01 pm

Hi guys,

I receive my CRS125 yesterday and i just notice something weird.
All ports are in 1Gbps except the ether3. I test the ethernet cable by switching ether2 and 3, and this is not the problem.

Should i send it back or there is an chance i can fix it by any software update?

CRS125-24G-15-RM
RouterOS 6.37.3 default configuration

Thanks for reading :)
 
User avatar
Janevski
newbie
Posts: 35
Joined: Sat Dec 31, 2016 10:29 pm
Contact:

Re: CRS125 ether3 fault

Sun Jan 01, 2017 5:12 pm

Under good enough light conditions visually inspect the ethernet connector and see if the pins are good.
Check the link negotiation settings.
Powercycle the board and check again.
 
tommy31
just joined
Topic Author
Posts: 2
Joined: Sat Dec 31, 2016 7:49 pm

Re: CRS125 ether3 fault

Sun Jan 01, 2017 7:55 pm

I already check the pins and link negociation. But thanks
 
User avatar
Janevski
newbie
Posts: 35
Joined: Sat Dec 31, 2016 10:29 pm
Contact:

Re: CRS125 ether3 fault

Sun Jan 01, 2017 8:08 pm

Since the obvious problem points are eliminated, i think you should return it ASAP.

Who is online

Users browsing this forum: No registered users and 15 guests