How do I set a RB1000 into netboot mode? I have a failing one which is in some boot loop after a failed upgrade attempt from v5 (beeps once every 10s).
I tried to shorten the C229 surface contact and also tried the undocumented button left of the LED but it still loops and does not seen to go into netboot mode
Just to rule out my setup is making an issue I also tried a RB450 which boots fine into netboot.
I looked at the backup of the router config it has the enable jumper reset enabled.
Code: Select all
set baud-rate=115200 boot-delay=2s boot-device=nand-if-fail-then-ethernet \
boot-protocol=bootp enable-jumper-reset=yes enter-setup-on=any-key \
force-backup-booter=no