I faced with problem - CRS328's SFP ports can't link with CRS125's SFP port in AutoNegotiation mode. When I set 1Gb link speed - it works. It is feature or bug ?

I got the same problems

Set auto 10gb sfp will be working okay if set manually 10gb it works at 1gb and cannot do any routing

From " What's new in 6.43.7 (2018-Nov-30 09:01):"
*) crs328 - fixed SFP ports not reporting auto-negotiation status;
*) crs328 - improved link status update on disabled SFP and SFP+ interfaces;


But it do not work.

I agree. It not working! After settings 10 GB manualy in status shows 1 GB and not working.

I have the same problem. Using cooper 10 GB cable is ok, but on using SFP Fiber 10 Gb not working. I try many settings.

I have same issue with SFP ports. Tested on 6.43.7 and 6.45.beta50.
If auto negotiation is enabled - no link
If auto negotiation is disabled - port is running but no incoming traffic

There is an issue I have picked up which I have sent through to support.
However on a CRS317, using bidi Mikrotik models. They only work on ROS 6.41 and lower, any higher version and no SFP model information is displayed and there is no link with either auto or no negotiation.

I've tried to downgrade to 6.41.3 - no changes. Still doesn't work.

Powercycle did help for two days, then ports went down again. Sorry to say that device is trash.