Hello,
I've just got my first RB4011 and it works fine except the port 10 which is POE port, wich give the rate of 10Mbps with POE
any idea..
Nizar
RB4011 POE problem
You do not have the required permissions to view the files attached to this post.
-
-
nescafe2002
Forum Veteran
- Posts: 897
- Joined:
- Location: Netherlands
Re: RB4011 POE problem
Didn't notice before, but I have the same issue: RB4011 <=> cAP ac autoneg 100Mbps, non-autoneg 1Gpbs.
Re: RB4011 POE problem
Are you guys(?) using GB compatible POE injectors?
https://mikrotik.com/product/RBGPOE
https://mikrotik.com/product/RBGPOE
Re: RB4011 POE problem
I think they are talking POE out, not in.Are you guys(?) using GB compatible POE injectors?
https://mikrotik.com/product/RBGPOE
Re: RB4011 POE problem
Yes, I'm using POE out !!
Re: RB4011 POE problem
My bad: no injectors involved. Have you checked with support, as that's hardware related?
Re: RB4011 POE problem
I'm also using an RB4011, ether10 is PoE powering an hAP AC correctly. What hardware are you using on port 10?
Re: RB4011 POE problem
I'm using an Aerohive AP
Re: RB4011 POE problem
Haven't seen the problem, I'm powering a cAP without any problems with PoE out from port10 on a RB4011. But the cAP only have 100Mb port.
Re: RB4011 POE problem [SOLVED]
Wait, does that device even support powering using Passive POE? I can see it supporting active POE over mode A, not passive/mode B.I'm using an Aerohive AP
Maybe it does but only using 100Mbit but can't find anything about it being officially supported for your device.
There is a difference between mode A and mode B POE, they use different cables and can cause different connection speeds if mixed incorrectly. Worst case they fry equipment! For more information about the differences, I wrote a bit about there here a while back.
Re: RB4011 POE problem
Yes, it looks like you are rightWait, does that device even support powering using Passive POE? I can see it supporting active POE over mode A, not passive/mode B.I'm using an Aerohive AP
Maybe it does but only using 100Mbit but can't find anything about it being officially supported for your device.
There is a difference between mode A and mode B POE, they use different cables and can cause different connection speeds if mixed incorrectly. Worst case they fry equipment! For more information about the differences, I wrote a bit about there here a while back.
unfortunately MT poe is Passive while Aerohive is Active.Thank you
Who is online
Users browsing this forum: No registered users and 12 guests