Hi mates.
I bought a set of CRS109-8G-1S-2HnD units and just found out that, even through it is 802.3af compliant, it's PoE compatibility is limited to a really small list of devices (https://wiki.mikrotik.com/index.php?tit ... lity_table).
My Cisco switch SG110-24HP isn't on the list, and i couldn't figure out how to power these units using it. Neither a direct cable or crossover cable did the trick. Tried multiple UTP's to isolate cabling problems.
Any ideas? I'm out of budget to purchase 802.3af to passive converters (https://www.ubnt.com/accessories/instan ... -adapters/) and would love to hear about a working case scenario using similar CRS109 and Cisco equipments. Even if i have to mess with the pin orders as this is a really small and controlled deploy.
Best regards