Could you, pretty please make an outdoor version of https://mikrotik.com/product/pwr_line_ap?
There are vertical outdoors weather/dust protected 220V EU shuko plugs with a lid.
Whenever the lid is closed, the plug is safe.
Whenever there is a cord attached, the plug is again safe.
I don't think there would be much of a design difference, except for no ventilation, perhaps a cubic cm or two bulkier plug (more plastic so it shuts the plug completely) and a small ethernet case modification.
The ethernet could be facing downwards and be protected from moisture by a case design, similar to the MikroTik wAP.
It's basically, same hardware model, a different case and you can sell it for double the price as an outdoor unit.
At 7W of power draw, as a comparison, a Samsung S4+ charger draws at least 10W and it's completely shut sealed, confined to a lot smaller case. So perhaps heat dissipation won't be much of an issue. In the long run, if the AC->DC adapter is good enough, i doubt it'll be an issue either.
Not sure if the plastic itself is sturdy enough, or should be a better rated one.
You know, the same bulky inside walls are even bulkier towards the outside and there's always usually an outdoor plug near the balcony/entrance.
This could also work greatly on European mobile construction sites, where everything is containerized in big metal cargo container housings, and power is quite modular and outdoors, so almost no ethernet needs to be deployed.