Working on configuring a 2011 and a 3011 and had a couple issues/questions:
1) According to the Switch Chip Features page, both Atheros chips involved support TX rate limiting. However whenever I try to set Egress Rate, I get an error: "rate limiting not supported". Has that feature been disabled, or am I missing something. I did see in a change log of an older firmware that maybe those features were hidden, but they aren't hidden in the webfig.
2) I'm trying to set the sfp and switch chip1 ports as a bridge with a management VLAN and a couple other VLANs. I saw where it was recommended with these chips to do the VLANs in the switch section rather than the bridge section to minimize impact on the cpu. On the 2011, the sfp is included in switch 1, so that's not a problem. On the 3011, the sfp is not part of the switch chip, so what's the recommended way to bridge the sfp and ports 1-5 with VLANs and minimize negative impact on the cpu? SFP is a trunk, one management VLAN, ports 1-3 each access ports with a different VLAN.
FW 6.44.2 and 6.44.3