Is there something special that needs to be done when using a GPEN21 to provide passive POE out?
I am attempting to power an SXT 5 ac with a GPEN21 that is in turn connected to a POE switch. When connecting the SXT to the POE out port the GPEN POE out light will turn on, however the SXT will not power on.
In the small amount of time I had to troubleshoot so far, I found SwOS is indicating a fault on that port and shows symbols under the "Pairs" column. However I am unable to find any information related to the reason for the fault or the information being displayed. Other than references to the GPEN21 having Link Fault Detection and a screenshot, the manual and other documentation doesn't appear to cover this in any detail.
I have a couple more troubleshooting steps I can take, however, it appears there is some issue with the interconnecting cable to the SXT. I have tried multiple factory terminated cables, both shielded and unshielded, with the same results. Using the provided passive injector and power supply I was able to previously configure the SXT prior to connecting it to the GPEN21 and currently have it operating in a temporary fashion using the same, so it appears the hardware is all good.
Suggestions of where to go next?