Hello,
Whe have purchased 3 units RBLtAP-2HnD&R11e-LTE&LR8 some months ago and every worked fine: we could go to the LoRa module and configure the gateway.
Last week (december 2021) we have purchased more than ten units of this same device and we cant use LoRa module:
- The routers came with RouterOS 6.47, but without the LoRa package installed
- After updating to RouterOS 6.49 mmips and install the LoRa package, we could enter in the LoRa config, but no gateway was detected.
- We have open one of the routers and it has the LoRa8 mini PCI in place. Even we have reconnected it to test if it was due to bad position. No luck.
- This happens in at least three of the new routers, the rest will be tested tomorrow.
¿any suggestion?
¿is it needed another package additionaly to lora one?
¿could be some additional config step required?
Thank you