I wasn't running at 100 % until this afternoon. I use intermapper and I wasn't having any issues until today becuase it lets me know when I hit 90 % use. Every so often it hits 100 % and I'm not sure how to find out what is causing it. The amount of bandwidth varies but is usely around 1 to 2 mgbs. Please advise.
It is a rb532 with duaghter board 564 on it. It is connected to a 768k up and 7.1 mgbs down dsl line. I have all connections limited to 40 or 50 per ip because I have 5 different ip ranges routed through this unit. This has had the same configuration for months.
5:28 am was the last time it was under high cpu usage and it is currently 7:48 am now which is strange becuase it had been hitting over 90% every 15 to 45 minutes all night long. The only thing that has happened was at 6:00 am when it sent a backup email to me.
No one was logged in at all when this was happening and so far it hasn't happened since 5:30 this morning. My intermapper was showing high cpu usage and I would lose connection to routerboard during the times I was actually trying to see what was going on. I figured it was a prolem with too many connections but I haven't found this to be true. I wish I knew what caused it but then again it wouldn't make me mad if it never done this again. If I see it start back up I post again but until then thanks for trying.