anyone experiencing reboot issues with RB493AH with RouterOS 3.2x ?
Actually - I only noticed it when the watchdog was rebooting the box due to non availability of a remote system.
It just reboots - then is stuck on the boot-menu.
Even if I tell it to reboot manually - connected through Serial Console to a linux box - however nothing is running on the serial terminal except when I connect to it using minicom - I see the messag where I have 2 Seconds to go to the boot menu - and then it jumpts into the boot menu anyway and waits.
Anyone has a hint on what to do ? It's kind of stupid if I'm away and have to ask "non-admin" people to go through the process to connect with minicom etc. and that box over the phone).
Booting is configured to go from NAND then from Ethernet. However - nothing to do.
smurphy@gw-sollan-RB493AH] /system routerboard> print routerboard: yes model: "493AH" serial-number: "XXXXXXXXXXXXXXX" current-firmware: "2.20" upgrade-firmware: "2.20"
[smurphy@gw-sollan-RB493AH] /system> watchdog print watch-address: XXX.XXX.XXX.XXX watchdog-timer: yes no-ping-delay: 5m automatic-supout: yes auto-send-supout: no
[smurphy@gw-sollan-RB493AH] /system routerboard settings> print baud-rate: 115200 boot-delay: 2s boot-device: nand-if-fail-then-ethernet enter-setup-on: any-key cpu-frequency: 680MHz boot-protocol: bootp enable-jumper-reset: yes force-backup-booter: no