Community discussions

MUM Europe 2020
 
jalokim
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 76
Joined: Thu Dec 07, 2006 1:39 pm
Location: PL, Tychy
Contact:

RB112 is resetting conifguration after power off

Mon Feb 15, 2010 11:20 am

Hi,
RouterBoard 112

CPU frequency: 175 MHz
  Memory size:  16 MB

Boot configuration reset, applying defaults
writing settings to flash... OK

Press any key within 2 seconds to enter setup..
loading kernel from nand... OK
setting up elf image... OK
jumping to kernel code
Starting...
Resetting system configuration...
Starting services...
I was tring to format nand and netinstall all from begening. Mem test show no probleblems.

Any ideas?
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24422
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: RB112 is resetting conifguration after power off

Mon Feb 15, 2010 11:36 am

make sure you have not shorted any jumpers on the board. if some wire is touching the reset jumper, this will happen
No answer to your question? How to write posts
 
jalokim
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 76
Joined: Thu Dec 07, 2006 1:39 pm
Location: PL, Tychy
Contact:

Re: RB112 is resetting conifguration after power off

Mon Feb 15, 2010 12:28 pm

make sure you have not shorted any jumpers on the board. if some wire is touching the reset jumper, this will happen
I've taken from board pin reset and dip switch reset. So there is no way to short this.
 
jalokim
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 76
Joined: Thu Dec 07, 2006 1:39 pm
Location: PL, Tychy
Contact:

Re: RB112 is resetting conifguration after power off

Tue Feb 16, 2010 6:43 pm

Nice to have support .... :/
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24422
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: RB112 is resetting conifguration after power off

Wed Feb 17, 2010 8:48 am

this is a user based forum, not a support system.

check if you don't have any damage on the PCB board, maybe there is a scratch or some solder traces that are causing the resets. Like I said, the jumper is the only thing that can reset it. Either that, or some connection leading to it.
No answer to your question? How to write posts

Who is online

Users browsing this forum: No registered users and 17 guests