Community discussions

MikroTik App
 
HaQs
Member Candidate
Member Candidate
Topic Author
Posts: 153
Joined: Sat Oct 20, 2007 3:26 pm
Location: POLAND

Netinstall new ROS on RB without RS232 when ROS is damage?

Sat Aug 21, 2010 7:44 pm

Hi.

Can I flash ROS image on RB with netinstall without using the RS232 to configure boot from ethernet ?

Sometimes Happen to damage when updating the ROS from the WLAN.

Alternatively, is there any option to change RB booting to: once boot from ethernet after boot from NAND? or something like that without RS232?
 
HaQs
Member Candidate
Member Candidate
Topic Author
Posts: 153
Joined: Sat Oct 20, 2007 3:26 pm
Location: POLAND

Re: Netinstall new ROS on RB without RS232 when ROS is damag

Tue Aug 24, 2010 9:24 pm

There is no such option?

There is a chance to add this option to ROS bootloader: If the long hold down the reset (10 sec) then RB boot from ethernet
 
fewi
Forum Guru
Forum Guru
Posts: 7734
Joined: Tue Aug 11, 2009 3:19 am

Re: Netinstall new ROS on RB without RS232 when ROS is damag

Tue Aug 24, 2010 9:33 pm

The available options are:
  • ethernet
    flash-boot
    flash-boot-once-then-nand
    nand-if-fail-then-ethernet
    nand-only
    try-ethernet-once-then-nand
 
roadracer96
Forum Veteran
Forum Veteran
Posts: 714
Joined: Tue Aug 25, 2009 12:01 am

Re: Netinstall new ROS on RB without RS232 when ROS is damag

Wed Aug 25, 2010 2:18 am

I normally get it by starting net-install and holding reset while power cycling then it net-boots...

Who is online

Users browsing this forum: 3net and 19 guests