I have the message on console jumping to kernel code
After reinstall via netinstall, it start to work, but, they show me it again when i switch power off and then again power on
After each installation, if i do only the reboot command, it start very nice. But in any time when i do the power off/on, it not start, coming only the message jumping to kernel code, and after some period try reboot again. I change the RAM, but it not help.
the voltage show 12,5V is it nice? May be change the PSU?

Can you test memory in BIOS? Hit any key and then "t"

try to change boot order.. i dont remember exactly but there are some options for boot ordering..

here is mentioned how to change boot order

http://blog.vodkamelone.de/archives/148 ... RB433.html

Can you test memory in BIOS? Hit any key and then "t"

as i think all tests was done well, because, when it reinstalled via netinstall, and not switch off/on, it work nice.

HELL0000O MIKROTIK STAFF!!!!

Anybody can help me, 5 days i try to understand what the problem with my newest RB1100, and can't find solution...
I don't have the chance to sent it to your dealer, and i see that it really work.

Why after power switching off/on it stop in "jumping to kernel code" section????
And why it work very nice, after reinstalling it via netinstall, until power off/on.
It still work with reboot commands, it work on version 5beta, and 4.11 relaseis only.
with 4.10 it come to "jumping to kernel code" and stop...

If you need a reply from the Mikrotik staff you should send an email to support@mikrotik.com. The forums are a community support option and there's no guarantee staff will ever read your thread.

try to install the version you have on other RB(you use RB)
if same error so version not good if all work fine the RB not good