"signal strength LED's", are you sure? there are no such LEDs on the OmniTik. this is an AP device, there is no specific signal to show (if you have 40 clients, each has different signal), the LEDs on the back are ethernet LEDs1. I can not get any of the units to fire up the signal strength LED's
please send a photo to support, the problem is not clear2. One of the units has a screw lodged in behind the signal strength LED and the window. this is a manufacturing quality control issue.
how did you test this? can you post more specific information about this problem?3. when set up and being tested the packet loss seems to be pretty high. This is with the unit under test in the workshop in what would have to be an optimum configuration.
you mean to say that there is no UDP traffic in actual networks ??you having ping packet loss when running on the UDP test, that's normal. UDP test doesn't mean the actual throughput it can handle.
then more better way is you use the TCP test with tcp count set to 20, then u can see the actual throughput it can carry when it's in live network.
I replied to comment above mineI was only stating what was reported by the test utilities provided in the device and not by an external device. UDP is critical to the base network's functionality and to be honest we should not be seeing such losses in an optimal test environment.
what speed is it supposed to provide? which speed are you getting (you didn't say)? you can't expect maximum speed if your client device is far away, or has a low gain antenna. you need to know some wireless basics, wireless is a very sensitive environment, the speed depends on too many factors. nobody guarantees speed in a wireless environment.secondly if i purchase a link that is supposed to provide a speed of X then i should be getting X and not X with high packet loss albeit UDP or TCP.
there is your problem. signal should be -60 not more. you have much too much signal.-37 to -43
yes, when there is no traffic, it stays on low rates, when the traffic increases, it goes to higher ratesWhen the link associated we it reported it was connected at either 6 or 9mbps however in the tests is showed a connection speed of 300/300 from memory.