Community discussions

MUM Europe 2020
Topic Author
Posts: 44
Joined: Thu Dec 20, 2007 9:04 pm

v5.22 upgrade problem

Wed Jan 02, 2013 6:05 pm

I have a RouterBoard 433 with a 5GHz XR-5 radio card and a 2.4GHz XR-2 radio card, both running AP mode. I was running v4.17 but was having problems with clients staying associated to the 5GHz XR-5. The 2.4GHz XR-2 was working fine. I upgraded to v5.22 and my problem with clients staying associated to the XR-5 card seems to be better. Now I have no associations to my 2.4GHz XR-2 card. Any ideas why? All settings seem to be the same. I have upgraded the firmware. I have disabled then enabled the XR-2 card.

Thanks ... Jay
User avatar
Posts: 371
Joined: Mon Jun 13, 2011 11:30 pm
Location: Warsaw

Odp: v5.22 upgrade problem

Wed Jan 02, 2013 11:26 pm

I haven't seen anything similar before, but I would suggest to turn it off, put the cards in different slots (2.4 in the one that was not in use, 5 in the previous 2.4 slot), turn it on, reset config, set up again.
Forum Veteran
Forum Veteran
Posts: 701
Joined: Wed Sep 23, 2009 7:52 pm

Re: v5.22 upgrade problem

Sun Jan 06, 2013 4:23 pm

jayk do they do something like connect/disconnect or they cant connect at all
if u use different brand for client CPE
MT v5.x in winbox on XR-2 see in wireless tab u can find option Wireless Protocol see if its set to unspecified or 802.11
User avatar
Forum Guru
Forum Guru
Posts: 2301
Joined: Wed Feb 27, 2008 10:27 pm
Location: Czech Republic

Re: v5.22 upgrade problem

Mon Jan 07, 2013 8:54 am

RB493G upgrade from 5.10(5.11) to 5.22
You do not have the required permissions to view the files attached to this post.
LAN, FTTx, Wireless. ISP operator

Who is online

Users browsing this forum: MrdotApple and 34 guests