Community discussions

MikroTik App
 
FutileNetworks
newbie
Topic Author
Posts: 37
Joined: Tue Jan 15, 2013 9:14 pm

sfp module not detected on RB2011UAS-RM

Thu Feb 07, 2013 4:16 am

As subject, purchased 2 SFP modules from mikrotik distributor, neither work in 2011UAS-RM using 5.23 and 6.0rc9, but they are detected in our CCR1036-12G-4S, from the CCR:

[admin@MikroTik] > /interface ethernet monitor sfp3
name: sfp3
status: link-ok
auto-negotiation: disabled
rate: 1Gbps
full-duplex: yes
sfp-module-present: yes
sfp-rx-lose: no
sfp-tx-fault: no
sfp-connector-type: LC
sfp-link-length-50um: 550m
sfp-link-length-62um: 270m
sfp-vendor-name: OEM
sfp-vendor-part-number: GLC-SX-MM-C
sfp-vendor-revision: A1
sfp-vendor-serial: TC1412180046
sfp-manufacturing-date: 12-12-18
sfp-wavelength: 850nm

Also tried another sfp module which also works in CCR but not in 2011UAS-RM

sfp-vendor-name: EDIMAX
sfp-vendor-part-number: MG-1000AMA
sfp-vendor-revision: 0000
sfp-vendor-serial: C416011856

How do I get these working?
 
User avatar
roc-noc.com
Forum Veteran
Forum Veteran
Posts: 873
Joined: Sun Dec 02, 2007 3:27 am
Location: Rockford, IL USA
Contact:

Re: sfp module not detected on RB2011UAS-RM

Thu Feb 07, 2013 4:43 am

I would think you should work this through your distributor. They should be selling and supporting compatible modules if they are selling both RouterBoards and SFPs.
-----------------------------------------------
http://www.roc-noc.com
Tom, CCNA, ISP, USA Mikrotik Distributor
888-762-5662
-----------------------------------------------
 
Dobby
Member
Member
Posts: 400
Joined: Wed Jan 11, 2012 12:07 am
Location: Hogwarts

Re: sfp module not detected on RB2011UAS-RM

Thu Feb 07, 2013 6:16 pm

Deleted because not related.
Last edited by Dobby on Mon Mar 11, 2013 1:15 am, edited 1 time in total.
 
FutileNetworks
newbie
Topic Author
Posts: 37
Joined: Tue Jan 15, 2013 9:14 pm

Re: sfp module not detected on RB2011UAS-RM

Fri Feb 08, 2013 10:01 pm

Turns out these modules work fine, the problem was auto negotiation on the CCR defaults to off and needed to be turned on (thanks Chaos @ linitx).
 
User avatar
nest
Forum Veteran
Forum Veteran
Posts: 820
Joined: Tue Feb 27, 2007 1:52 am
Location: UK
Contact:

Re: sfp module not detected on RB2011UAS-RM

Wed Mar 20, 2013 4:30 pm

This has been acknowledged by MT as something that will be fixed in the next release.
Ron Touw - Mikrotik Certified Consultant and Trainer
Freeclix.com
 
gilito
just joined
Posts: 7
Joined: Thu Nov 13, 2014 10:02 am

Re: sfp module not detected on RB2011UAS-RM

Sun Feb 07, 2021 2:24 pm

Hi!

The same with 35LC20D and 53LC20D pair.
I tested with an RJ45 SFP and port works. So I think is about firm/soft issue

On RB3011 I can se module present, led on and how version an tx/rx power
On Rb2011 unable to see nothing

Routerboard info
/system routerboard> print 
                ;;; Firmware upgraded successfully, please reboot for changes to take effect!
       routerboard: yes
             model: 2011UAS
     serial-number: 374802D1AEF8
     firmware-type: ar9344
  factory-firmware: 3.0rc5
  current-firmware: 6.45.3
  upgrade-firmware: 6.48
  
SFP monitor
/interface ethernet> monitor sfp1 
                      name: sfp1
                    status: no-link
          auto-negotiation: done
               advertising: 
  link-partner-advertising: 
               sfp-rx-loss: yes
                  sfp-type: (unknown)
           eeprom-checksum: good
                    eeprom: 0000: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0010: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0020: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0030: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0040: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0050: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0060: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0070: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0080: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            0090: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00a0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00b0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00c0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00d0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00e0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........
                            00f0: 00 00 00 00 00 00 00 00  00 00 00 00 00 00 00 00  ........ ........

Resources info
/interface ethernet> /system resource print    
                   uptime: 1w5h1m1s
                  version: 6.48 (stable)
               build-time: Dec/22/2020 11:20:49
              free-memory: 92.5MiB
             total-memory: 128.0MiB
                      cpu: MIPS 74Kc V4.12
                cpu-count: 1
            cpu-frequency: 600MHz
                 cpu-load: 10%
           free-hdd-space: 104.3MiB
          total-hdd-space: 128.0MiB
  write-sect-since-reboot: 678175
         write-sect-total: 70360738
               bad-blocks: 0%
        architecture-name: mipsbe
               board-name: RB2011UAS
                 platform: MikroTik
If needed more info or screnshots, I can do!

Thanks
 
quackyo
Member Candidate
Member Candidate
Posts: 165
Joined: Mon Nov 16, 2015 10:14 am

Re: sfp module not detected on RB2011UAS-RM

Mon Feb 08, 2021 10:20 am

Your 2011 might actually be too old.
I had a really old 2011 at a time that didn't take my SFP's. Support said that there was some revisions of the board, and that the really old ones didnt work correctly with some or all SFP's.

Who is online

Users browsing this forum: No registered users and 34 guests