I just bought 2 CCR1016-12G from Streakwave to replace my RB1000AHX2(s).
got them configured properly and they have been running for 5 days.
Have a slight Problem.
Have 2 100Meg Ethernet channels connected to RB411U(s)
one on ether7, one on ether5.
on day 2 ether7 stopped working. so moved it to ether9
end of day 5, ether5 stopped working had to move it to ether10.
Put a Network monitor on the two dead Ethernet ports. They are receiving (and can be seen in torch), but
they are not transmitting, no signal,
Is there a problem with this new production?
do I need to go back to my RB1000AHX2(s)
???
W. Mark Esser.