I'm trying to add an external PSU to compliment the internal PSU in the CCR (CCR1016-12G) and make it redundant so I need to make an extra wiring loom to the secondary PSU connector.
See image here :- http://forum.mikrotik.com/viewtopic.php?f=3&t=69422
Can anyone advise the name of the connector?
Its a 3 pin latching style +-12.25mm x 16.20mm. I have googled a few of the obvious manufacturers (molex etc) but can't seem to find the specific one.
Can anyone see any obvious issue with a 19V 4.7A (90W capable) DC power supply being the secondary external PSU?
Normis has confirmed 18V-28V is ok. I wanted to have a wide voltage margin to ensure the backup would never be used normally but it was easy to monitor via System > Health if the external PSU was in use.