a problem :



blinking :

open the case and see if the lcd connector is firmly attached

open the case and see if the lcd connector is firmly attached

when booting, it showing normaly, bottom line

still, it is recommended to check the connector.

if connector is OK, make sure you run the latest RouterOS version 6.1 and run the "/lcd recalibrate" command

Try to upgrade the bootloader:

Try to upgrade the bootloader:

Code: Select all

/system routerboard upgrade
/system reboot

upgrade and connector's recheking didn't help

still, it is recommended to check the connector.
if connector is OK, make sure you run the latest RouterOS version 6.1 and run the "/lcd recalibrate" command

recalibrating didn't work, only white line is blinking


version is : MikroTik RouterOS 6.1 (c) 1999-2013

p.s.: after and of boot'ing, in right corner starting blinking, and after second, full line starting blinking..

please show me output of "/system routerboard print", also please tell me, which RouterOS version you had before upgrading to this one

please show me output of "/system routerboard print", also please tell me, which RouterOS version you had before upgrading to this one

[admin@MikroTik] > /system routerboard print
routerboard: yes
model: 2011UAS
serial-number: 427102312***
current-firmware: 3.08
upgrade-firmware: 3.08
[admin@MikroTik] >

i' didn't make any upgrade's today..

p.s. except your's command's, befor it your's command's was same 3.08

p.s.s.: i didn't wan't reset configuration.. but time is money....

it seem's like software bug, reset help in this situation..

but after restoring configuration - same think happened again..

attaching supout.rif

Try to upload this file to the device, and run "/system routerboard upgrade"

Try to upload this file to the device, and run "/system routerboard upgrade"

[admin@MikroTik] > /system routerboard print
routerboard: yes
model: 2011UAS
serial-number: 427102312***
current-firmware: 3.06
upgrade-firmware: 3.06
[admin@MikroTik] >

downgrade'ing didn't hellp

uninstalling LCD package will help. The LCD package is not for routertboard.

uninstalling LCD package will help. The LCD package is not for routertboard.

confirming - helped