Power Break during Upgrade

medube · Fri Apr 21, 2006 12:00 pm

Hi,

I was recently upgrading my RB532 and had a power break in the middle. Since it came back up, I cannot seem to have any communication with the borad. Though it powers up as normal but I cant seem to have any contact with it.

Is there anything I can do, please help...

VicNet · Fri Apr 21, 2006 12:31 pm

Very bad,

Your board is broken.

Please contact with your board suppiler mayeby they can help you.

medube · Fri Apr 21, 2006 12:33 pm

Ok. If I slot in a CF card will it override the onboard memory and load from CF?

Fri Apr 21, 2006 12:33 pm

how about output from serial console?

medube · Fri Apr 21, 2006 12:34 pm

Hi I tried to see it thru serial, I get Loading fro Nand OK and then it goes System Halted.

Fri Apr 21, 2006 12:40 pm

try to reinstall RouterOS with netinstall:
http://www.mikrotik.com/docs/ros/2.9/guide/netinstall

medube · Fri Apr 21, 2006 1:51 pm

try to reinstall RouterOS with netinstall:
http://www.mikrotik.com/docs/ros/2.9/guide/netinstall

Thank you Normis, so far I have been able to install using netinstall. After the first reboot it goes thru all the normal bootup process, but then just stops on Starting Services...

Is there anything else I must do?

Thanks again

cmit · Fri Apr 21, 2006 1:52 pm

Try changing your baudrate. Sounds like the console could be configured to use another baud rate...

Best regards,
Christian Meis

medube · Fri Apr 21, 2006 2:01 pm

Thank you guys, it worked out well. I really appreciate the assisstance and suggestions.

Thanks again

Power Break during Upgrade

Power Break during Upgrade

Who is online