Page 1 of 1
Power Break during Upgrade
Posted: Fri Apr 21, 2006 12:00 pm
by medube
Hi,
I was recently upgrading my RB532 and had a power break in the middle. Since it came back up, I cannot seem to have any communication with the borad. Though it powers up as normal but I cant seem to have any contact with it.
Is there anything I can do, please help...
Posted: Fri Apr 21, 2006 12:31 pm
by VicNet
Very bad,
Your board is broken.
Please contact with your board suppiler mayeby they can help you.
Posted: Fri Apr 21, 2006 12:33 pm
by medube
Ok. If I slot in a CF card will it override the onboard memory and load from CF?
Posted: Fri Apr 21, 2006 12:33 pm
by normis
how about output from serial console?
Posted: Fri Apr 21, 2006 12:34 pm
by medube
Hi I tried to see it thru serial, I get Loading fro Nand OK and then it goes System Halted.
Posted: Fri Apr 21, 2006 12:40 pm
by normis
Posted: Fri Apr 21, 2006 1:51 pm
by medube
Thank you Normis, so far I have been able to install using netinstall. After the first reboot it goes thru all the normal bootup process, but then just stops on Starting Services...
Is there anything else I must do?
Thanks again
Posted: Fri Apr 21, 2006 1:52 pm
by cmit
Try changing your baudrate. Sounds like the console could be configured to use another baud rate...
Best regards,
Christian Meis
Posted: Fri Apr 21, 2006 2:01 pm
by medube
Thank you guys, it worked out well. I really appreciate the assisstance and suggestions.
Thanks again