Hi!

If we take a look at first example @ http://wiki.mikrotik.com/wiki/Manual:CRS_examples

In my scenario I would like to have also native (untagged) vlan (1) passing through ether2 and going to let say ether5

Is it possible to somehow get it trough?

Hi

I just had a similiar problem with CRS125.
I wanted to set a trunk port on ether1-master (VLAN100 (VoIP), VLAN101 (Guests) + native VLAN (LocalNet)).
On CRS I have three DHCP servers (each VLAN + native)
Port ether24 is indepedenet (no master) and is used for wan (internet Access).

All Wiki CRS Examples have the trunk port (ether2) only with tagged VLANs no native VLAN.
In my Scenario I would like to connect to port ether1-master a Procurve switch but only VLANs were being transmitted (local net wasnt working).

Until I added the following: I am not sure if this is the correct implementation or not. But it is working!