Community discussions

 
ik3umt
Member Candidate
Member Candidate
Topic Author
Posts: 248
Joined: Tue Jul 08, 2014 3:58 pm

ethernet port hardware (?) issue

Fri Apr 24, 2015 9:58 am

I have a rb2011 with an ethernet port (7) often has "no link"
there is no way to turn it up again other than a power supply reset
I tried all possible negotiations on the port as well on the attached device ethernet
also a software reboot produces nothing positive (replaced cable of course)
On ether6 is connected an identical device , if i swap eth6 with eth7 , 7 is still down while 6 goes up

Not yet tried to move 7 to 8 (rb is on service at customer)

Some other rb2011 had this behaviour sometime but it is gone after a power cycle and never re-appeared

Is it a known issue ? is it definitively an hardware malfunctioning ?

Who is online

Users browsing this forum: No registered users and 18 guests